PDA

View Full Version : Set system control parameters for specific network device



kobuse
12-Aug-2015, 10:12
I am using a network interface (zVM Vswitch - IBM OSA card) - eth0 and HiperSockets - hsi0. The two networks works 100% but I would like to do some tuning. I know that you can set system wide parameters in /etc/sysctl.conf. My question is : How do you override the system wide setting (it is set up as optimal for the virtual switch interface eth0). I want to set specific parameters (for example - net.core.wmem_max = 524288 and net.core.rmem_max = 524288) to optimize the HiperSocket (hsi0) interface. The current settings in sysctl.conf is net.core.wmem_max = 4194304 and net.core.rmem_max = 4194304. (Optimal for the the eth0 device)


Any help would be appreciated

Automatic reply
17-Aug-2015, 05:30
kobuse,

It appears that in the past few days you have not received a response to your
posting. That concerns us, and has triggered this automated reply.

Has your issue been resolved? If not, you might try one of the following options:

- Visit http://www.suse.com/support and search the knowledgebase and/or check all
the other support options available.
- You could also try posting your message again. Make sure it is posted in the
correct newsgroup. (http://forums.suse.com)

Be sure to read the forum FAQ about what to expect in the way of responses:
http://forums.suse.com/faq.php

If this is a reply to a duplicate posting, please ignore and accept our apologies
and rest assured we will issue a stern reprimand to our posting bot.

Good luck!

Your SUSE Forums Team
http://forums.suse.com