PDA

View Full Version : SLES-Other SLES 11 SP1 LPAR - Expanded memory



mikenash
06-Apr-2016, 19:32
How do I query expanded memory. Also, what book is the configuration found?

Automatic reply
11-Apr-2016, 05:30
mikenash,

It appears that in the past few days you have not received a response to your
posting. That concerns us, and has triggered this automated reply.

These forums are peer-to-peer, best effort, volunteer run and that if your issue
is urgent or not getting a response, you might try one of the following options:

- Visit http://www.suse.com/support and search the knowledgebase and/or check all
the other support options available.
- Open a service request: https://www.suse.com/support
- You could also try posting your message again. Make sure it is posted in the
correct newsgroup. (http://forums.suse.com)

Be sure to read the forum FAQ about what to expect in the way of responses:
http://forums.suse.com/faq.php

If this is a reply to a duplicate posting or otherwise posted in error, please
ignore and accept our apologies and rest assured we will issue a stern reprimand
to our posting bot..

Good luck!

Your SUSE Forums Team
http://forums.suse.com

smflood
11-Apr-2016, 10:40
On 06/04/16 19:34, mikenash wrote:

> How do I query expanded memory. Also, what book is the configuration
> found?

I'm not sure exactly what you're asking for here - do you want a command
to find how much memory your server has or are you after something else?

You should note that SLES11 SP1 is no longer supported, not even under
Long Term Service Pack Support (LTSS).

HTH.
--
Simon
SUSE Knowledge Partner

------------------------------------------------------------------------
If you find this post helpful and are logged into the web interface,
please show your appreciation and click on the star below. Thanks.
------------------------------------------------------------------------

mikenash
11-Apr-2016, 13:35
Greetings Simon, I have a system that was experiencing poor performance because of a shortage of memory. I found out that it had 3G expanded memory. I issued modprobe xpram devs=3. Then went into yast hardware xpram and started the service. The performance got better but free does not show expanded memory. How can I monitor expanded memory utilization?