View Full Version : SLES 11 SP4 HA: how to configure basic setup manually

29-Jun-2016, 14:16

currently i'm trying to establish a two-node cluster. I'm reading https://www.suse.com/documentation/sle_ha/book_sleha/data/cha_ha_installation.html .
There are two ways to configure the basic setup: yast and sleha-bootstrap. I'd like to configure it manually, that means editing the configuration files. I'd prefer that because then i know more what i do and also learn more.
Is there a doc or a howto for that ?



Automatic Reply
04-Jul-2016, 05:30

It appears that in the past few days you have not received a response to your
posting. That concerns us, and has triggered this automated reply.

These forums are peer-to-peer, best effort, volunteer run and that if your issue
is urgent or not getting a response, you might try one of the following options:

- Visit http://www.suse.com/support and search the knowledgebase and/or check all
the other support options available.
- Open a service request: https://www.suse.com/support
- You could also try posting your message again. Make sure it is posted in the
correct newsgroup. (http://forums.suse.com)

Be sure to read the forum FAQ about what to expect in the way of responses:

If this is a reply to a duplicate posting or otherwise posted in error, please
ignore and accept our apologies and rest assured we will issue a stern reprimand
to our posting bot..

Good luck!

Your SUSE Forums Team

05-Jul-2016, 13:55
Hi Bernd,

> I'd like to configure it manually [....] Is there a doc or a howto for that ?

you may want to start by looking at the Pacemaker (and its config files) documentation. And starting with the overview documentation you referenced, you may find according tutorials on the net on configuring OpenAIS.

It's been some time I had to do our setup from scratch, but I don't recall having ever used YaST for that :) AFAIR, it all boils down to the stuff in /etc/corosync/corosync.conf.