I am having a problem with SP2 and SP3 installers.

After i installed (following instructions https://www.youtube.com/watch?v=66zw_YM2yY8 )

Suse does not boot straight to GRUB and will need the USB with DVD.iso again (using the "boot from hard disk" option) to boot Suse

Partitions were set as

/dev/nvem0n1p1 -> type BIOS boot (code EF02)
/dev/nvem0n1p2 -> swap ; type MS basic data (code 0700)
/dev/nvem0n1p3 and p4 type MS data (code 0700)

gdisk output is -> GPT fdisk (gdisk) version 0.8.8

I have tried a lot of different combinations during installation (partitions, check MBR option on booting, custom boot, secureboot etc. ) , but all have same output (does not boot)

If there are additional info needed for this please tell me. Ive been using suse with the USB drive plugged in since sunday just to make it work.

Hope someone helps