Dear Comunity,
we have following Problem, we have a two nodes configuration,
we have SAP Hana running with SAP Hana Replication between the two nodes
and SAP ASCS and PAS installed on the first node (No ERS)

We can move SAP from one nodeA to nodeB without any problems, this works fine, and also HANA Take over works fine.

Our problem is following:
When we put the Primary Node in Standby first of all the PAS and ASCS should be stopped and then the HANA take over should be started and in our case all runs in parallel,
stop of PAS and take over.
We need some constraint, colocation, tried some ones but without success.
Does any one of you the same configuration, or one similar?
or some examples of a configuration where SAP is installed on the same node with HANA?
or just some recommendations how to configure this constraint?

Regards.

Manuel