we are moving from NetWare to OES2
I have setup the SLES 11 server that we are going to be using and I am
slowly moving services over to it.

our old NW server routed traffic between two network and I need the new
SLES 11 server to do the same thing.

eth0 = 10.0.1.21
eth1 = 10.0.2.21

(following various bits of information I've gathered searching google)
I made the following changes in /etc/sysconfig/SuSEfirewall2
FW_DEV_EXT="any eth0"
FW_DEV_INT="eth1"
FW_ROUTE="yes"
FW_MASQUERADE="yes"
FW_MASQ_DEV="zone:ext"
FW_MASQ_NETS="0/0"

so...
devices connected to eth1 can connect to everything on eth0.
devices connected to eth0 cannot connect to anything on eth1.
and that seems to make sense - this looks like a typical firewall setup,
let traffic from eth1 masquerade to eth0.

I'm not sure if I messed up a setting or went in the complete wrong
direction. Is there a simpler way to route 2 networks without using
masquerade?