Hi Folks

We need to do a clean re-install of SLES 10.3 on a HP server.
We trashed the hardware RAID partitions on the HP DL380G7 and re-created them and then went for our install but the installation fails with the following message:
"The partitioning on disk /dev/cciss/c0d0 is not readable by the partitioning tool parted with is used to change the partition table."

We have lots of SLES servers running on the same hardware platform in the same config and this problem only seems to be an issue on re-installs. There are 2 RAID 5 arrays - 8 disks of 1TB which the system can definitely see but apparantly not read. To test the hardware I managed to install W2K R2 so am assuming they are fine.

Have had a look throught he boards but can't find anything that seems to fit.
Any suggestions warmly welcomed folks!!

Cheers