AutoYast fails to configure the network with following configuration:

Boot options:
nameserver=192.168.35.240 domain=example.com.local splash=none showopts
netwait=10 gateway=192.168.20.254 hostip=192.168.40.220/24
netdevice=eth1 autoyast=http://192.168.40.141//yast/auto.xml clock=pmtmr

Network settings in the AutoYaST xml file. MAC addresses and IPs have
been adjusted. The installer system boots from the management interface
eth1 (192.168.40.0/24). After running the installation, no network
configuration for eth0 or eth1 is written to /etc/sysconfig/network. Set
up of routing, DNS etc works just fine. Parameters for the interfaces
were taken from the autoinstall.xml file of a previous installation.

<networking>
<dns>
<dhcp_hostname config:type="boolean">false</dhcp_hostname>
<domain>example.com.local.local</domain>
<hostname>test5</hostname>
<nameservers config:type="list">
<nameserver>192.168.35.240</nameserver>
</nameservers>
<resolv_conf_policy>auto</resolv_conf_policy>
<searchlist config:type="list">
<search>example.com,example.com.local</search>
</searchlist>
<write_hostname config:type="boolean">false</write_hostname>
</dns>
<interfaces config:type="list">
<interface>
<bootproto>static</bootproto>
<device>eth0</device>
<broadcast>192.168.20.255</broadcast>
<ipaddr>192.168.20.133</ipaddr>
<name>82545EM Gigabit Ethernet Controller (Copper)</name>
<netmask>255.255.255.0</netmask>
<prefixlen>24</prefixlen>
<startmode>auto</startmode>
<usercontrol>no</usercontrol>
</interface>
<interface>
<bootproto>static</bootproto>
<device>eth1</device>
<broadcast>192.168.40.255</broadcast>
<device>eth1</device>
<ipaddr>192.168.40.33</ipaddr>
<name>82545EM Gigabit Ethernet Controller (Copper)</name>
<netmask>255.255.255.0</netmask>
<prefixlen>24</prefixlen>
<startmode>auto</startmode>
<usercontrol>no</usercontrol>
</interface>
</interfaces>
<managed config:type="boolean">false</managed>
<net-udev config:type="list">
<rule>
<name>eth0</name>
<rule>ATTR{address}</rule>
<value>00:50:56:81:05:56</value>
</rule>
<rule>
<name>eth1</name>
<rule>ATTR{address}</rule>
<value>00:50:56:81:05:57</value>
</rule>
</net-udev>
<routing>
<ip_forward config:type="boolean">false</ip_forward>
<routes config:type="list">
<route>
<destination>default</destination>
<device>-</device>
<gateway>192.168.20.254</gateway>
<netmask>-</netmask>
</route>
</routes>
</routing>
</networking>

So what is wrong here?

GŁnther