Hi all,

I am on SLES11 sp3 and I am trying to connect a new Seagate Slimline USB drive.
But the drive is not show anywhere.

lsusb:
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 006 Device 002: ID 03f0:1027 Hewlett-Packard Virtual keyboard and mouse
Bus 006 Device 003: ID 03f0:1327 Hewlett-Packard


dmesg:
[ 3617.276071] usb 1-6: new high-speed USB device number 2 using ehci_hcd
[ 3617.415096] usb 1-6: New USB device found, idVendor=0bc2, idProduct=ab10
[ 3617.415102] usb 1-6: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 3617.415105] usb 1-6: Product: Slim SL
[ 3617.415107] usb 1-6: Manufacturer: Seagate
[ 3617.415109] usb 1-6: SerialNumber: NA4QN0WT
[ 3617.449771] Initializing USB Mass Storage driver...
[ 3617.450687] scsi3 : usb-storage 1-6:1.0
[ 3617.450773] usbcore: registered new interface driver usb-storage
[ 3617.450775] USB Mass Storage support registered.
[ 3618.449475] scsi 3:0:0:0: Direct-Access Seagate Slim SL 0936 PQ: 0 ANSI: 6
[ 3618.449714] sd 3:0:0:0: Attached scsi generic sg1 type 0
[ 3618.458008] sd 3:0:0:0: [sda] Spinning up disk........................
[ 3644.096435] usb 1-6: USB disconnect, device number 2
[ 3645.020070] .ready
[ 3645.020154] sd 3:0:0:0: [sda] READ CAPACITY(16) failed
[ 3645.020157] sd 3:0:0:0: [sda] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[ 3645.020162] sd 3:0:0:0: [sda] Sense not available.
[ 3645.020194] sd 3:0:0:0: [sda] READ CAPACITY failed
[ 3645.020197] sd 3:0:0:0: [sda] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[ 3645.020200] sd 3:0:0:0: [sda] Sense not available.
[ 3645.020216] sd 3:0:0:0: [sda] Write Protect is off
[ 3645.020219] sd 3:0:0:0: [sda] Mode Sense: ff 57 00 5c
[ 3645.020233] sd 3:0:0:0: [sda] No Caching mode page present
[ 3645.020236] sd 3:0:0:0: [sda] Assuming drive cache: write through
[ 3645.021055] sd 3:0:0:0: [sda] READ CAPACITY(16) failed
[ 3645.021058] sd 3:0:0:0: [sda] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[ 3645.021062] sd 3:0:0:0: [sda] Sense not available.
[ 3645.021095] sd 3:0:0:0: [sda] READ CAPACITY failed
[ 3645.021098] sd 3:0:0:0: [sda] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[ 3645.021101] sd 3:0:0:0: [sda] Sense not available.
[ 3645.021126] sd 3:0:0:0: [sda] No Caching mode page present
[ 3645.021129] sd 3:0:0:0: [sda] Assuming drive cache: write through
[ 3645.021131] sd 3:0:0:0: [sda] Attached SCSI disk


fdisk -l does not show anything about this USB.
Any ideas?

Best regards
Claus, DK