Hi,

I have issue with the hard drive device detection on DELL PowerEdge R710. For some reason during the installation, AutoYaST picks up Virtual Floppy (sdb) and LCDrive (sda) and the actual RAID drive (sdc). The system has a PERC 6/i controller with RAID 10 configuration. Is there a way to tell AutoYaST not to pickup those virtual devices?

I tried to use skip list in partition profile and it does not seem to work.

.... snip ....
<initialize config:type="boolean">true</initialize>
<!-- the skip_list is optional and available since openSUSE 12.2 and SLES11 SP2 -->
<skip_list config:type="list">
<listentry>
<!-- skip devices that use the usb-storage driver -->
<skip_key>driver</skip_key>
<skip_value>usb-storage</skip_value>
</listentry>
<listentry>
<!-- skip devices that are smaller than 1GB -->
<skip_key>size_k</skip_key>
<skip_value>1048576</skip_value>
<skip_if_less_than config:type="boolean">true</skip_if_less_than>
</listentry>
<listentry>
<!-- skip devices that belongs to DELL BP -->
<skip_key>vendor</skip_key>
<skip_value>DP</skip_value>
</listentry>
<listentry>
<!-- skip devices that are iDRAC -->
<skip_key>vendor</skip_key>
<skip_value>iDRAC</skip_value>
</listentry>
</skip_list>
... snip ...

Thanks

--Guang