Results 1 to 2 of 2

Thread: No hard disks were found for installation

  1. #1

    No hard disks were found for installation

    while installing SLES12SP2 on IBM 8284-22A, getting error No hard disks were found for installation

    sd 1:0:2:0: [sdb] Read Capacity(16) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
    sd 1:0:1:0: [sda] Read Capacity(16) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
    sd 1:0:2:0: [sdb] Sense Key : Not Ready [current]
    sd 1:0:1:0: [sda] Sense Key : Not Ready [current]
    sd 1:0:2:0: [sdb] Add. Sense: Logical unit not ready, initializing command required
    sd 1:0:1:0: [sda] Add. Sense: Logical unit not ready, initializing command required
    sd 1:0:2:0: [sdb] Read Capacity(10) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
    sd 1:0:1:0: [sda] Read Capacity(10) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
    sd 1:0:1:0: [sda] Sense Key : Not Ready [current]
    sd 1:0:2:0: [sdb] Sense Key : Not Ready [current]
    sd 1:0:1:0: [sda] Add. Sense: Logical unit not ready, initializing command required
    sd 1:0:2:0: [sdb] Add. Sense: Logical unit not ready, initializing command required
    sd 1:0:1:0: [sda] Test WP failed, assume Write Enabled
    sd 1:0:2:0: [sdb] Test WP failed, assume Write Enabled
    sd 1:0:1:0: [sda] Asking for cache data failed
    sd 1:0:2:0: [sdb] Asking for cache data failed
    sd 1:0:2:0: [sdb] Assuming drive cache: write through
    sd 1:0:1:0: [sda] Assuming drive cache: write through
    sd 1:0:2:0: [sdb] Spinning up disk...
    sd 1:0:1:0: [sda] Spinning up disk...
    .

  2. #2

    Re: No hard disks were found for installation

    kulwinder97,

    It appears that in the past few days you have not received a response to your
    posting. That concerns us, and has triggered this automated reply.

    These forums are peer-to-peer, best effort, volunteer run and that if your issue
    is urgent or not getting a response, you might try one of the following options:

    - Visit http://www.suse.com/support and search the knowledgebase and/or check all
    the other support options available.
    - Open a service request: https://www.suse.com/support
    - You could also try posting your message again. Make sure it is posted in the
    correct newsgroup. (http://forums.suse.com)

    Be sure to read the forum FAQ about what to expect in the way of responses:
    http://forums.suse.com/faq.php

    If this is a reply to a duplicate posting or otherwise posted in error, please
    ignore and accept our apologies and rest assured we will issue a stern reprimand
    to our posting bot..

    Good luck!

    Your SUSE Forums Team
    http://forums.suse.com



Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •