# SLES 11 QLE2360 **URL:** \ **Category:** SLES Hardware\ **Created:** [September 10, 2013, 9:22pm UTC](https://forums.suse.com/t/sles-11-qle2360/24480 "2013-09-10T21:22:34Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![stvns78](https://avatars.discourse-cdn.com/v4/letter/s/7bcc69/32.png) [@stvns78](https://forums.suse.com/u/stvns78)\ **Post date:** [September 10, 2013, 9:22pm UTC](https://forums.suse.com/t/sles-11-qle2360/24480/1 "2013-09-10T21:22:34Z")
I have a QLogic QLE2360 Fibre Channel HBA that i have installed in the system below: SUSE Linux Enterprise Server 11 (x86\_64) VERSION = 11 PATCHLEVEL = 1 LSB\_VERSION=“core-2.0-noarch:core-3.2-noarch:core-4.0-noarch:core-2.0-x86\_64:core-3.2-x86\_64:core-4.0-x86\_64” SLES recognizes the adapter on boot and seems to load the qla2xxx driver however i am unable to find any devices. I have tried a full rescan of all scsi devices, I have installed the SANSurfer software which recognizes the QLE2360 however it keeps saying that there is no connection. The back of the card has 3 LEDs (green, amber, red) the green and red are solid which means: Power On (After Firmware Init and/or Loss). It is recognized as a scsi device and it appears in the system information, i have also updated the drivers from QLogic. I have exhausted all my searching for a solution. Can anyone give any insight as to what i am missing. I tried modprobing it, rebooting, but i am not sure whats going on. Thanks Mike ---
**Author:** ![Jens-U](https://avatars.discourse-cdn.com/v4/letter/j/d78d45/32.png) [@Jens-U](https://forums.suse.com/u/Jens-U)\ **Post date:** [September 12, 2013, 2:36am UTC](https://forums.suse.com/t/sles-11-qle2360/24480/2 "2013-09-12T02:36:35Z")
Hi Mike, how’s the adapter set up, loop-wise? What do the /sys entries tell about the link state? Do you have a zoned SAN behind the adapter, are all targets granting permission to your adapter WWPN to access the resources? What does the FC switch tell about the adapter/port, has your HBA logged in etc? Regards, Jens