OSA Layer 3 support of HA configuration in Wicked-Nanny

cthsiaocthsiao New or Quiet Member
Hello, all:
IBM zServer OSA support both layer-2 mode and layer-3 mode. The performance when running in layer-3 mode is much higher than layer-2 when offloading feature (segmentation, checksum) is enabled. But from the HA point of view, traditionally the layer-2 is preferred as managing the MAC is more easy than in layer 3 mode, where the layer-2 work is done by the OSA microcode.
I'm not very sure that the wicked-nanny NIC HA functions(including teaming or bonding) supports OSA layer-3 mode or not. If so, which release? Thanks a lot.

Victor Hsiao.


  • Automatic ReplyAutomatic Reply No Reply Posting Bot

    It appears that in the past few days you have not received a response to your
    posting. That concerns us, and has triggered this automated reply.

    These forums are peer-to-peer, best effort, volunteer run and that if your issue
    is urgent or not getting a response, you might try one of the following options:

    - Visit http://www.suse.com/support and search the knowledgebase and/or check all
    the other support options available.
    - Open a service request: https://www.suse.com/support
    - You could also try posting your message again. Make sure it is posted in the
    correct newsgroup. (http://forums.suse.com)

    Be sure to read the forum FAQ about what to expect in the way of responses:

    If this is a reply to a duplicate posting or otherwise posted in error, please
    ignore and accept our apologies and rest assured we will issue a stern reprimand
    to our posting bot..

    Good luck!

    Your SUSE Forums Team
Sign In or Register to comment.