On Sun 10 Apr 2016 04:34:01 PM CDT, serge n wrote:

Thanks for your answer, but, of course, I have tried ctrl+alt+F1 before
I send a request, without success.
Graphic card is nvidia G960.

I am back with previous kernel.

Regards,

Serge


Hi
So did you update/rebuild the Nvidia driver? If not after a kernel
update this is needed. If you boot to runlevel 3 after the kernel
update then rebuild the driver from the run file then all should be
good.

Else are you pulling the rpm from the repo, these can be out of sync at
times, I've always used the run file so can update, reboot, rebuild....

You may, since your running SP4 is to use sax2 and rebuild the
xorg.conf file (again after the driver update and at runlevel 3)

Code:
sax2 -r -m 0=nvidia
Configure screen in the GUI, save at run;
Code:
init 5 && exit
--
Cheers Malcolm °¿° LFCS, SUSE Knowledge Partner (Linux Counter #276890)
SUSE Linux Enterprise Desktop 12 SP1|GNOME 3.10.4|3.12.53-60.30-default
If you find this post helpful and are logged into the web interface,
please show your appreciation and click on the star below... Thanks!